Minebea CSD-912B - Page 79

59
Measurement
5
5.2. Preparation of measurement
8) Set [PRELIM2]
>35(/,0@LVWKHVWDQGDUGYDOXHWRFRQWURORSHQFORVHRIWKHIXOOÀRZJDWHRIWKHEUDQG
KRSSHU,QFDVHRI>6,03/(&203$5$7,9(@WKHIXOOÀRZJDWHRSHQVZKHQWKHZHLJKLQJ
YDOXHUHDFKHV>),1$/@>35(/,0@,QFDVHRI>6(48(17,$/02'(@WKHIXOOÀRZJDWH
FORVHVZKHQWKHZHLJKLQJYDOXHUHDFKHV>),1$/@>35(/,0@
1. Tap [PRELIM2].
7KHVFUHHQWRVHW>35(/,0@ZLOOEHGLVSOD\HG
2. Enter the value of [PRELIM2].
$OORZDEOHUDQJHWR
Default: 0
POINT
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.
- If the setting value of [PRELIM2] is equal
to [PRELIM1] or less and the setting
value of [PRELIM2] is not 0, the
VHTXHQFHHUURU>64(55@ZLOOEH
displayed at the start of measurement.
Change the settings of [PRELIM1] and
[PRELIM2] in order not to meet the
above condition.
3. Tap [OK].
>35(/,0@KDVEHHQVHWDQG>%5$1'&2'(@
ZLOOEHGLVSOD\HG
9) Set [OVER]
>29(5@LVWKHTXDQWLW\WKDWH[FHHGVWKHTXDQWLW\WRPHDVXUH>),1$/@:KHQDZHLJKLQJ
value reaches "[FINAL]+[OVER]," the [OVER] lamp lights.
1. Tap [OVER].
7KHVFUHHQWRVHW>29(5@ZLOOEHGLVSOD\HG
2. Enter the value of [OVER].
$OORZDEOHUDQJHWR
Default: 0
POINT
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.