Minebea CSD-912B - Page 94

74
Measurement
5
5.4. Measurement in sequential mode
POINT
6HTXHQFHFRQWUROVFUHHQFRQVLVWVRIWKUHHSDJHV5HIHUWR+RZWRVZLWFK
VFUHHQVIRUPRUHLQIRUPDWLRQDERXWKRZWRVZLWFKSDJHV
(1) Operation settings at batch start
(QWHUWKHVHWWLQJVQRWWRVWDUWÀRZGXHWRDVHTXHQFHHUURULIWKHZHLJKLQJYDOXHLVHTXDOWRRU
OHVVWKDQWKHVHWWLQJYDOXHRI>=(52%$1'@ZKHQEDWFKVWDUWVLJQDOVDUHLQSXW
$OVRHQWHUWKHVHWWLQJVDVWRZKHWKHUWRDXWRPDWLFDOO\H[HFXWHWDUHZLJKWFDQFHOODWLRQZKHQ
batch start signal are input ([AUTOMATIC TARE]).
POINT
5HIHUWR7DUHZHLJKWFDQFHOODWLRQIRUPRUHLQIRUPDWLRQDERXWWDUHZLJKW
cancellation.
1) Display the Operation settings screen for batch start
1. Tap [BATCH START SEQUENCE] on
[SEQUENCE CONTROL 1/3].
2SHUDWLRQVHWWLQJVVFUHHQIRUEDWFKVWDUWZLOOEH
displayed.
2) Set the operation of [START ABOVE ZERO BAND]
1. Tap [START ABOVE ZERO BAND].
The screen to set [START ABOVE ZERO BAND]
ZLOOEHGLVSOD\HG
2. Tap [VALID]/[INHIBIT].
Default: [INHIBIT]
3. Tap [OK].
The operation of [START ABOVE ZERO BAND] has
been set, and Operation settings screen for batch
VWDUWZLOOEHGLVSOD\HG
3) Set the operation of [AUTOMATIC TARE]
1. Tap [AUTOMATIC TARE].
7KHVFUHHQWRVHW>$8720$7,&7$5(@ZLOOEH
displayed.