Minebea CSD-912B - Page 95

75
Measurement
5
5.4. Measurement in sequential mode
2. Tap [VALID]/[INHIBIT].
Default: [INHIBIT]
3. Tap [OK].
The operation of [AUTOMATIC TARE] has been
set, and Operation settings screen for batch start
ZLOOEHGLVSOD\HG
(2) Settings of waiting time until batch start
6HWWKHZDLWLQJWLPHIURPWKHLQSXWRIEDWFKVWDUWVLJQDOVXQWLOWKHEDWFKVWDUWRIPHDVXUHGREMHFWV
1) Display the screen to set the waiting time until batch start
1. Tap [BATCH START DELAY TIMER] on
[SEQUENCE CONTROL 2/3].
7KHVFUHHQWRVHWWKHZDLWLQJWLPHXQWLOEDWFKVWDUW
ZLOOEHGLVSOD\HG
2) Set the waiting time until batch start
1. Enter the waiting time until batch start.
$OORZDEOHUDQJHWR
Default: 0
POINT
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.
2. Tap [OK].
7KHZDLWLQJWLPHXQWLOEDWFKVWDUWKDVEHHQVHWDQG
>6(48(1&(&21752/@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHYDOXHRIWKHZDLWLQJWLPHXQWLO
batch start.
The setting is completed if the value set by the step
2) appears under [BATCH START DELAY TIMER].
(3) Settings of tare operation after waiting time until batch start elapses
6HWZKHWKHUWRDXWRPDWLFDOO\H[HFXWHWDUHZHLJKWFDQFHOODWLRQDIWHUWKHZDLWLQJWLPHXQWLO
batch start elapses.
POINT
5HIHUWR7DUHZHLJKWFDQFHOODWLRQIRUPRUHLQIRUPDWLRQDERXWWDUHZLJKW
cancellation.