Minebea CSD-912B - Page 96

76
Measurement
5
5.4. Measurement in sequential mode
1) Display the screen to set tare operation after the waiting time until batch start elapses
1. Tap [TARE BATCH START DELAY] on
[SEQUENCE CONTROL 2/3].
7KHVFUHHQWRVHWWDUHRSHUDWLRQDIWHUWKHZDLWLQJ
WLPHXQWLOEDWFKVWDUWHODSVHVZLOOEHGLVSOD\HG
2) Enter tare operation after the waiting time until batch start elapses
1. Tap [VALID]/[INHIBIT].
Default: [INHIBIT]
2. Tap [OK].
7KHWDUHRSHUDWLRQDIWHUWKHZDLWLQJWLPHXQWLOEDWFK
start elapses has been set, and [SEQUENCE
&21752/@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHWDUHRSHUDWLRQDIWHUWKHZDLWLQJ
time until batch start elapses.
The setting is completed if the item set by the step
2) appears under [TARE BATCH START DELAY].
(4) [F-FLOW COMP. STOP TIMER] settings
6HWWKHWLPHWRSURKLELWFRPSDULVRQDWWKHVWDUWRIPHDVXUHPHQWEHWZHHQWKHYDOXHRI
>),1$/@>35(/,0@RI>%5$1'&2'(@DQGWKHZHLJKLQJYDOXH
1) Display the screen to set [F-FLOW COMP. STOP TIMER]
1. Tap [F-FLOW COMP. STOP TIMER] on
[SEQUENCE CONTROL 2/3].
The screen to set [F-FLOW COMP. STOP TIMER]
ZLOOEHGLVSOD\HG
2) Set [F-FLOW COMP. STOP TIMER]
1. Enter [F-FLOW COMP. STOP TIMER].
$OORZDEOHUDQJHWR
Default: 0.00
POINT
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.