Minebea CSD-912B - Page 97

77
Measurement
5
5.4. Measurement in sequential mode
2. Tap [OK].
[F-FLOW COMP. STOP TIMER] has been set, and
>6(48(1&(&21752/@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHYDOXHRI>))/2:&2036723
TIMER].
The setting is completed if the value set by the step
2) appears under [F-FLOW COMP. STOP TIMER].
(5) [M-FLOW COMP. STOP TIMER] settings
6HWWKHWLPHWRSURKLELWFRPSDULVRQDWWKHHQGRIIXOOÀRZEHWZHHQWKHYDOXHRI>),1$/@
>35(/,0@RI>%5$1'&2'(@DQGWKHZHLJKLQJYDOXH
1) Display the screen to set [M-FLOW COMP. STOP TIMER]
1. Tap [M-FLOW COMP. STOP TIMER] on
[SEQUENCE CONTROL 2/3].
The screen to set [M-FLOW COMP. STOP TIMER]
ZLOOEHGLVSOD\HG
2) Set [M-FLOW COMP. STOP TIMER]
1. Enter [M-FLOW COMP. STOP TIMER].
$OORZDEOHUDQJHWR
Default: 0.00
POINT
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.
2. Tap [OK].
[M-FLOW COMP. STOP TIMER] has been set, and
>6(48(1&(&21752/@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHYDOXHRI>0)/2:&2036723
TIMER].
The setting is completed if the value set by the step
2) appears under [M-FLOW COMP. STOP TIMER].