183
Kaleido-X
User’s Manual
end and blank end—, set the refresh rate and other timing parameters so that they
match those of the physical display you need to configure.
Example: Suppose you want to configure the display that is connected to head 1 of a
Kaleido-X (7RU) multiviewer’s OUTPUT D card. The image below shows the relevant data
you need to copy to the Modeline section of the Edit Resolution Settings window.
Note: In XAdmin’s Status and Options page, these parameters are listed
under the corresponding output card information, according to the
blank/sync start/end modeline system, and with the sync polarity expressed
as a number between 0 and 3. Refer to
Viewing a Multiviewer’s Status
Information, on page 433 for details.
To Next Page
Loading...
