Miranda Kaleido-X16 - Assigning a Logical Source to a Monitor by Using the RCP-200

45
Kaleido-X
User’s Manual
The label of each category/index button in Assign Source is based on recurring strings
found in the logical source names available for your system. The Src box shows the
current assignment.
2 Click through the categories until the Pst box shows the logical source you wish to
assign to the selected monitor. For example, if you wish to assign the logical source
named “/Input B/Channel 16” to the monitor, click Input B, 1, and then 6.
3Click Take.
The selected logical source is now assigned to the monitor.
4 Click the × button to close the Assign Source window.
Assigning a Logical Source to a Monitor by Using the RCP-200
Although logical source assignments can be accomplished via the CHANNEL monitor wall
function (see
page 45), you may find the RCP-200’s category/index router view more
convenient. To use the RCP-200’s category/index panel, your multiviewer system must have
been configured to be controlled as a router. In a layout, the RCP-200 can only control
monitors that have been assigned a monitor wall destination.
To assign a logical source to a monitor, by using the RCP-200’s Category/Index panel
1 Select the appropriate head from the room view, by rotating the HEAD knob (or by
touching the DISPLAY SELECT category, and then touching the desired room display), if
needed.
2 Touch the monitor whose source assignment you wish to change.
The monitor’s border turns yellow, indicating that this monitor is a monitor wall
destination, and the RCP-200’s category/index panel appears on the left-hand screen.
The label of each category/index button is based on recurring strings found in the
logical source names available for your system. The Src and Dst areas show the current
source assignment and the monitor wall destination number for the selected monitor.
3 Touch through the categories until the Pst area shows the logical source you wish to
assign to the selected monitor. For example, if you wish to assign the logical source
named “/Input B/Channel 16” to the monitor, touch Input B, 1, and then 6.
4Press Take.
The selected logical source is now assigned to the monitor.
To assign a logical source to a monitor, by using the RCP-200’s CHANNEL knob
1 Touch the WALL MOUSE category if it is not already selected, and then move the
pointer over the composite or video monitor whose source assignment you wish to
change.