48
Operation of the Monitor Wall
Changing Crosspoints
The video from the first video level assignment within the selected logical source
appears in the video window.
When the current layout is reloaded, either of the following two situations may apply.
• No logical source: If there was no logical source associated with the monitor, then
the Kaleido-X will remember the new source assignment.
• Not a monitor wall destination: If the monitor was not already configured as a
monitor wall destination, then the layout will be reloaded in its initial state, as it
was configured in XEdit.
Viewing Assignment Information
To view the current assignment information for a video monitor
• Right-click the video monitor, and then point to Info on the menu.
The following information appears, as a submenu:
Dest Name associated with this monitor when considered as a
destination in the context of the KX Router logical router
Src Name of the logical source currently assigned to this
monitor.
Phy Identifier associated with the physical multiviewer input
providing the current signal to this monitor.
Notes
• In the case of a Kaleido-IP, the physical input information (Phy) is not
relevant.
• The information shown is not dynamic. To view the latest information,
close the menu, and then open it again.
• The physical input information (Phy) indicates “Unassigned” when there
are no logical source assigned to the monitor, or when the current logical
source does not include any video level.
Current logical source
Physical source ID
Monitor-wall destination
To Next Page
Loading...
