407
Kaleido-X
User’s Manual
Assigning a static IP address to the Kaleido-RCP2
To assign a static IP address to the Kaleido-RCP2
1 Press and hold the ENTER button until the ESC button lights up, to display the
configuration menu.
2Press the 8 key (to move down the list) until ETHERNET OPTIONS appears on the LCD
display.
3 Press the ENTER key to display the ETHERNET OPTIONS menu.
4 Select the IP ADDRESS menu using the 2 key (to move up in the list) or the 8 key (to
move down the list), and then press ENTER.
5 Using the numeric keypad, type the chosen IP address, and then press ENTER.
6 Select the NETWORK MASK menu using the 2 key (to move up in the list) or the 8 key
(to move down the list), and then press ENTER.
7 Using the numeric keypad, type the chosen network mask, and then press ENTER.
You have assigned a static IP address to the Kaleido-RCP2.
Selecting a Room for the Kaleido-RCP2
To select a room for the Kaleido-RCP2
1 Press and hold the ENTER button until the ESC button lights up, to display the
configuration menu.
2 In the ROOM SELECTION display, press ENTER again to get the room list from the
Kaleido-X systems that are currently available on the network.
3 In the room list, select the room you wish to access by pressing the 2 key (to move up in
the list) or the 8 key (to move down the list).
Note: By default, a multiviewer’s video outputs are assigned to specific
rooms:
• On a Kaleido-X (7RU), the two DVI/VGA outputs from each of the dual-
head Output cards A, B, C and D are assigned to ROOM1, ROOM2,
ROOM3 and ROOM4 respectively.
• On a Kaleido-X (4RU), the two DVI/VGA outputs from each of the dual-
head Output cards A and B are assigned to ROOM1 and ROOM2
respectively.
• On a Kaleido-X (14RU) expansion system, the two DVI/VGA outputs
from each of the dual-head Output cards A, B and C of each of Frame A
and Frame B are assigned to ROOM1, ROOM2, ROOM3, ROOM4, ROOM5
and ROOM6 respectively.
• On a Kaleido-X16-D, the HDMI outputs from each of the Output
modules are assigned to ROOMX16.
• On a Kaleido-X16-S, the HDMI output is assigned to ROOMX16.
• On a KMV-3901/3911, Kaleido-XQUAD, or Kaleido-XQUAD-DUAL, the
HDMI outputs are assigned to ROOM1.
• On a Kaleido-IP, the multiviewer outputs are assigned to ROOM.
To Next Page
Loading...
