46
Operation of the Monitor Wall
Assigning Sources to Monitors
2 If you have yet to assign the CHANNEL wall function to one of the programmable
knobs, rotate the knob you wish to program until CHANNEL is selected, and then press
the knob.
CHANNEL appears above the programmed knob.
3 Press the CHANNEL knob.
The Assign Source window appears on the monitor wall.
The label of each category/index button in Assign Source is based on recurring strings
found in the logical source names available for your system. The Src box shows the
current assignment.
4 Click through the categories until the Pst box shows the logical source you wish to
assign to the selected monitor. For example, if you wish to assign the logical source
named “/Input B/Channel 16” to the monitor, click Input B, 1, and then 6.
5Click Take.
The selected logical source is now assigned to the monitor.
6 Click the × button to close the Assign Source window.
Assigning a Logical Source to a Monitor by Using the Mouse
To assign a logical source to a monitor, by using the mouse
1 Right-click the monitor that is to be assigned a logical source.
2 On the shortcut menu, point to Assign source to [component] (where [component]
will be monitor, video, UMD, tally, audio meter, status alarm, time code, metadata
display, subtitling, or clock, depending on the monitor you clicked).
To Next Page
Loading...
