219
Kaleido-X
User’s Manual
To set the underscan/overscan properties of a video monitor
1 In XEdit, open a layout and click the video monitor for which you wish to configure the
underscan/overscan behavior.
The Underscan/Overscan settings appear in the Properties pane.
2Choose Underscan (to display the entire video signal) or Overscan (to display a
cropped video signal) from the drop-down menu beside Mode.
3 To specify custom crop settings, click in the white area to the right of Custom overscan,
then click the button that appears.
Note: Double-click the video monitor, if is part of a composite monitor.
To Next Page
Loading...
