Miranda Kaleido-X16 - Using XEdit Online; Connecting to a Multiviewer

59
Kaleido-X
User’s Manual
2 Choose a value from the Default DVI resolution list.
3Click OK.
Enabling EDID Auto-Detection from the Monitor Wall
To enable EDID auto-detect for a display
1 Right-click the monitor wall background, and then click Display Resolution on the
shortcut menu.
2 Select the Use detected monitor resolution check box.
Notes
• The Kaleido-IP multiviewers do not yet support automatic output
resolution detection.
• The monitor EDID auto-detection feature is enabled by default in order to
facilitate the initial setup of a Kaleido-X system. Setting an output head to
a specific resolution, from a multiviewer service panel in iControl (if
available), from the monitor wall (Kaleido-IP, Kaleido-X, Kaleido-X16), or
from a Densité controller’s local control panel (Kaleido-MX,
Kaleido-Modular-X, KMV-3901/3911, Kaleido-XQUAD) disables the EDID
auto-detection for this head.