269
Kaleido-X
User’s Manual
Detailed Directions
Creating Monitor Wall Actions
Monitor wall actions can be assigned to a monitor on a specific layout. Such actions can
only be triggered when that layout is loaded on the monitor wall.
To assign a monitor wall action to a monitor
1 Open the layout that contains the monitor to which you wish to assign an action, or
create a new layout.
2In the Layouts tab, unlock the appropriate composite monitor if applicable (see
Unlocking a Composite Monitor, on page 260), and then click the monitor you wish to
configure.
3In the Properties pane, click the Mouse click box, under Actions/Scripts.
4 Click the button that appeared at the end of the box you clicked.
The Action Editor window appears.
5In Action Editor, drag the appropriate action item from the Action List pane to the
middle pane under either the Single Click or Double Click tab.
6 Select the action in the middle pane.
7 In the right pane, specify the attributes of the action.
8 Repeat the procedure if you wish to add action items. If multiple actions are specified,
the trigger (e.g. single click on UMD) will cause all of these actions to be executed in
order.
Note: For a UMD, three action types can be set, and there is a box for each
under Actions/Scripts: Left tally - Mouse click, Right tally - Mouse click, and
UMD click.
To Next Page
Loading...
