190
Setting Up Rooms
Configuring Displays
3 Select the appropriate unit of measurement from the list that appears inside the
Height box and type the height.
4On the File menu, click Save.
Changing a Display’s Width
To change the width of a display in a room
1 Click the display whose width you wish to configure.
2Click the Width box in the Properties pane.
3 Select the appropriate unit of measurement from the list that appears inside the Width
box and type the width.
4On the File menu, click Save.
Changing a Display’s Rotation
To change the rotation setting for a display in a room
1 Click the display you wish to configure.
2Click the Rotation box in the Properties pane.
The rotation presets appear.
Notes
• The Kaleido-MX, Kaleido-Modular-X, Kaleido-XQUAD, and KMV-
3901/3911 multiviewers do not support display rotation.
•The Display Rotation option must be enabled on the corresponding
output card (in the case of a Kaleido-X multiviewer) or HDMI output port
(in the case of a Kaleido-X16) for rotation to work properly on the monitor
wall. The option can be enabled and verified in XAdmin’s Status and
Options page (see
Hardware and Software Options, on page 383).
• The Kaleido-IP supports display rotation. If two displays are connected to
the multiviewer, then they must both have the same orientation. It is not
yet possible to enable or verify the rotation option in XAdmin’s Status and
Options page, for this multiviewer model. Contact Technical Support for
activation and configuration instructions (see
Contact Us, on page 453).
To Next Page
Loading...
