212
Creating Layouts
Managing Layouts
3In Pick a Color, click the RGB tab, and then set the Red to 254, Green to 0 and Blue to
254.
4Click OK.
5 If the area you wish to configure for background keying covers more than one head,
repeat the procedure for the remaining heads, by clicking the corresponding areas in
the layout.
Note: Since bright pink colors matching the RGB values listed below are
considered pass-through colors, and since background keying is always
enabled, if a layout's background color (or any monitor's color attribute) is
set to any of these RGB values, the DVI input will be displayed in the
corresponding areas on the monitor wall. If there is no signal at the
associated DVI input (or the multiviewer does not support DVI input, as
would be the case with a KMV-3901/3911 or Kaleido-IP), residual data may
be visible in such areas.
• Pass-through colors: RGB (254,0,254), (254,0,255), (254,1,254),
(254,1,255), (255,0,254), (255,0,255), (255,1,254), (255,1,255)
Do not use these colors for any monitor's color attributes. A layout's
background should only be set to such a color if a DVI input will be
contributing the actual background for this layout on the monitor wall.
To Next Page
Loading...
