31
Kaleido-X
User’s Manual
• Has the RCP user configuration you wish to use been replicated on every member
of the cluster (see
Replicating RCP Users Across a Cluster System, on page 86)?
• Do you need to control an external router whose configuration is available only
from one or some specific members of the cluster?
• Does your system configuration include actions that were configured only on one
or some specific members of the cluster?
• Do you need to control a timer from the monitor wall in a cascade room?
If any of the above elements is available only from one or some specific members, then
make sure you select the room name prefixed with the appropriate multiviewer name.
In the case of a cascade room, unless you remember which multiviewer you were
connected to when you added the timer you need to control, you will have to proceed
by trial and error.
2 Touch the room you wish to access (press the DOWN or UP soft keys to scroll the list as
needed).
3 If the list of users assigned to this room appears on the right-hand screen, touch the
user name under which you wish to log on, enter your password, and then touch LOG
IN.
The room’s monitor wall control panel appears on the right-hand screen, with the
ASSIGN CHANNEL category selected. If a mouse is connected to the RCP-200, then after
touching WALL MOUSE you should be able to see and move the mouse pointer on the
monitor wall.
For more information on the RCP-200, please refer to the RCP-200 Guide to Installation and
Operation, available on the DVD that shipped with your system, and from Miranda’s support
portal.
Note: By default, the user “Admin” has no password.
Notes
• If the ROUTER SELECT category becomes selected instead of ASSIGN
CHANNEL, showing the following message on the right-hand screen:
“Please select a router from the left-hand screen,” then you still need to
complete the correlation between some monitor wall destinations and the
representation of the corresponding KX Router logical router.
See
Correlating Monitor Wall Destinations and KX Router Logical Routers for
the RCP-200 on page 405.
• The RCP-200 will remember your user credentials until you log out
explicitly (by touching LOG OUT at the upper-right corner of the control
panel).
• The pointer may flicker when two RCP users access displays fed by the
same multiviewer output.
• Two users accessing the same display will be limited to sharing a single
pointer.
To Next Page
Loading...
