440
Administration and Servicing
Restarting and Shutting Down a Kaleido-IP Multiviewer
The system prompts you to confirm.
5Click Ye s to proceed.
Your multiviewer will shut down, and then start again, during which time you can
observe messages associated with the Linux shutdown and boot sequences on the
monitor wall display connected to Head 1. This may take a while.
Once the multiviewer has restarted, the system notifies you.
6Click OK.
The XAdmin Status and Options page appears.
Shutting Down a Kaleido-IP Multiviewer
To shut down a Kaleido-IP multiviewer
1 From a workstation on the same subnet, open a Web browser window and type the IP
address of the multiviewer in the address bar.
The Kaleido-X home page appears.
2 Click the XAdmin button.
The XAdmin Status and Options page appears.
Note: Clicking the “Reset multiviewer” button on the Status and Options
page for a Kaleido-IP is equivalent to the above procedure except that, in the
first case, you get no feedback from XAdmin.
Firefox users:
If you see a security warning instead of the home page, then refer to
Registering your Multiviewer's Security Credentials with your Browser, on
page 421.
To Next Page
Loading...
