Installation
127
Mitel 415/430 as of R4.1
syd-0580/1.2 – R4.1 – 08.2016
Connection
Tab. 58 Connection of FXS terminal interfaces
Multifunctional FXS interfaces
The analogue interfaces of the FX cards are multifunctional. Depending on the terminal
or function they are configured individually in the Interface configuration using and
switched over internally accordingly.
Tab. 59 Mode of the FXS interfaces
After a first start all the FXS interfaces are configured on Phone / Fax.
Warning
Terminals connected to FXS interfaces can be damaged if the configuration of the FXS inter-
face mode is unsuitable.
Note
Circuit type as per EN/IEC 60950: TNV-2
Communication server Cable cores Connection socket
Socket Pin
Analogue
signal
Analogue
signal
Pin Socket
1– –1
2– –2
3– –3
4a a4
5b b5
6– –6
7– –7
8– –8
FXS mode Socket
Phone/fax Analogue DTMF and pulse dialling terminals such as phones, fax, modem, answering
machines, etc.
2-wire door Analogue two-wire door intercom
Control output Ports for switching external equipment.
Control input Ports for switching internal switch groups.
General bell Commercial auxiliary bells
To Next Page
Loading...
