Mitel 430 - About this Document

Product and Safety Information
14
Mitel 415/430 as of R4.1
syd-0580/1.2 – R4.1 – 08.2016
1. 5 About this document
This document contains information on the expansion stages, system capacity, installa-
tion, configuration, running and maintenance as well as the technical data of the
MiVoice Office 400 communication servers. The system functions and features, the
DECT planning and the possibilities for networking several systems into a private net-
work (PISN) or an Mitel Advanced Intelligent Network (AIN) are not part of this Manual;
they are described in separate documents.
The document is intended for planners, installers and system managers of phone
equipment. Basic knowledge of phones, especially ISDN and IP technology, is required
to understand the content.
The system manual is available in Acrobat Reader format and can be printed out if
necessary. Navigation in PDF format is based on the bookmarks, table of contents,
cross references and index. All these navigation aids are linked, i.e. a mouse click
takes you directly to the corresponding places in the Manual. We have also ensured
that the page numbering in the PDF navigation corresponds to the page numbering of
the Manual, making it much easier to jump to a particular page.
Referenced menu entries and parameters appearing on terminal displays or on the
user interfaces of the configuration tools are highlighted in italics and in colour for a
clearer orientation.
Document information
• Document number: syd-0580
• Document version: 1.2
• Valid as of / based on: R4.1 / R4.1
• © 08.2016 Mitel Schweiz AG
• In PDF viewer, click on this link to download the latest version of this document:
https://pbxweb.aastra.com/doc_finder/DocFinder/syd-0580_en.pdf?get&DNR=syd-0580
Hazard alert messages
Special hazard alert messages with pictograms are used to signal areas of particular
risk to people or equipment.
Hazard:
Failure to observe information identified in this way can put people and hardware at risk through
electrical shock or short-circuits respectively.
Warning:
Failure to observe information identified in this way can cause a defect of the product or to a
module.
Note:
Failure to observe information identified in this way can lead to equipment faults or malfunctions
or affect the performance of the system.