Mitel 430 - DECT Terminals

Operation and Maintenance
196
Mitel 415/430 as of R4.1
syd-0580/1.2 – R4.1 – 08.2016
Relocating a phone
The assigned port can be modified in the terminal configuration via WebAdmin, and the
phone connected on the new slot. The terminal configuration data is preserved.
Phones with a different level of added features
If a phone is replaced with another type of phone, most of the terminal configuration
data can be taken over using Multi edit. A separate Multi edit (keys) function is availa-
ble for the key configuration. Details can be found in the WebAdmin help for the view
Standard terminals ( =qd).
6. 3. 7. 2 DECT terminals
Replacing a radio unit
1. Dismantle the defective radio unit.
2. Fit the new radio unit.
Note:
If the ports of a radio unit are to be changed or if a radio unit is no longer used, it is important to
remove the radio unit in the system configuration. If not, start-up problems may occur when
another radio unit is connected to the same ports.
Replacing a cordless phone (a phone without microSD card)
1. Cancel the registration of the old cordless phone.
2. Register the new cordless phone. The cordless phone data is preserved until the
user number is also deleted.
Cancelling the registration of a cordless phone on the system
In WebAdmin in the edit view of the cordless phone, click Cancel registration.
Tip:
The identification of the cordless phone is deleted only if the cordless phone is located within
the coverage range of a radio unit; otherwise, it must be deleted manually on the cordless
phone (see the cordless phone’s User’s Guide). The user number and data in the system are
retained.