Mitel 430 - Page 221

Operation and Maintenance
221
Mitel 415/430 as of R4.1
syd-0580/1.2 – R4.1 – 08.2016
No response from network No answer to Call Setup on BRI-T/PRI interface Port number of the
exchange line circuit,
date, time
Normal
(without
match)
No response from user No answer to incoming DDI call from user on S
bus or DSI
DDI No., date, time
Normal
(without
match)
Node: Connection lost A node is not connected to the Master for a cer-
tain amount of time (configurable).
Node number, date,
time
critical
(negative,
with
match)
Node: Connection re-estab-
lished
A node is reconnected with the Master for a cer-
tain amount of time (configurable) after an inter-
ruption.
Node number, date,
time
critical
(positive,
with
match)
Not enough licences for inte-
grated mobile/external
phones
The connection setup with an integrated
mobile/external phone has failed because the
number of configured mobile/external phones is
greater than the number of licences available.
All the integrated mobile/external phones
remain blocked until a sufficient number of
licences are available.
Number of licences,
number of configured
mobile/external
phones, date, time
Serious
(negative,
with
match)
NTP: Time synchronisation
failed
Time synchronization via the NTP server (NTP =
Network Time Protocol) has failed.
Date, time
Serious
(negative,
with
match)
NTP: Time synchronisation
re-established
Time synchronization via the NTP server (NTP =
Network Time Protocol) has been restored.
Date, time
Serious
(positive,
with
match)
Outgoing call rejected Call rejected by the network
• On any line: error code 34
• On required line group:
error code 44
Port number of the
exchange line circuit,
cause, date, time
Normal
(without
match)
Overheat (Mitel 415/430
only)
The temperature inside the communication
server is too high. The appropriate measures
must be taken immediately to improve the heat
dissipation, e.g. by providing the required clear-
ances, lowering the ambient temperature or
installing the fan from the rack-mounting set
(Mitel 430 only).
Card number, tem-
perature, date, time
critical
(negative,
with
match)
Event message Trigger condition Details
1)
Severity