Mitsubishi 700 Series - Page 248

PROTOCOL-SPECIFIC INFORMATION
235
9
Bit
Value
Significance
Description
0 Speed Out Of Tolerance
Actual value differs from the reference value or
is outside of the tolerance as indicated by SU.
Refer to register 100 bit 3.
9
1 Control Requested
Control by PLC is possible when the operation
mode status (register 101) is reporting network
operation.
0 No Control Requested
Control is not possible by the controller when the
operation mode status (register 101) is not
reporting network operation mode. The inverter
must be explicitly set to network operation
mode.
10
1
Frequency Reached Or
Exceeded
The actual value ≥ max reference value. Refer
to Pr. 1 (maximum frequency).
0 Frequency Not Reached
The actual value < max reference value. Refer
to Pr. 1 (maximum frequency).
11 - 15
Not used
---
---