*2
Pr. 340 settings "2” and “12" are mainly used for communication operation using the inverter’s RS-485
port. When a value other than "9999" (automatic restart after momentary power failure) is set in Pr. 57
Restart coasting time, the inverter will resume the same operation state which it was in prior to a
momentary power failure is such a failure occurs. When Pr. 340 is set to "1” or “10" and a start command
is active, then the start command will be deactivated if a momentary power failure occurs.
*3
The operation mode can be changed between PU mode and NET mode with the key on the
operating panel (FR-DU07) and X65 signal.
To Next Page
Loading...
