Mitsubishi 700 Series

MITSUBISHI CONFIGURATION STUDIO
59
5
The card is discovered, configured and updated by the Mitsubishi Configuration Studio PC application.
The studio must be installed prior to connecting a card to ensure that the appropriate USB drivers are
installed. The studio will typically require a USB connection for reading/writing a configuration and
updating the firmware. Depending on the currently-active drivers, remote discovery, network setting, and
firmware updates are also possible via Ethernet. The latest release of the Configuration Studio can be
downloaded from the product web page
. The remainder of this section will provide only a brief
introduction to the configuration concepts. For protocol-specific configuration, refer to the relevant
protocol section.
Creating a Device Configuration
A device can be added to the Project panel for configuration by first selecting the Device
Configurations list heading and then:
• Double-clicking on the device in the Available Devices panel.
• Right-clicking on the device in the Available Devices panel and choosing Add from the context-
sensitive menu.
• Hitting the <ENTER> key on the keyboard when the device is selected in the Available Devices
panel.
• Dragging the device from the Available Devices panel into the Project panel.
• Selecting it and selecting Add Selected Device from the Edit menu.
• Selecting it and clicking the Add button in the toolbar.
The device will then be added to the list of Device Configurations.