FX3U Series Programmable Controllers
User’s Manual - Hardware Edition
152
8 Installation In Enclosure
8.5 Procedures for Installing on and Detaching from DIN Rail
8.5.2 Installation of main unit
The main unit must be installed before installing a expansion board or special adapter on the enclosure.
→ For the connection procedure, refer to Subsection 8.7.2, 8.7.3, and 9.5.2.
1 Push out all DIN rail mounting hooks (A in
the right figure).
2 Fit the upper edge of the DIN rail mounting
groove (C in the right figure) onto the DIN
rail.
3 Lock the DIN rail mounting hooks (D in the
following figure) while pressing the PLC against the DIN rail.
11
A
C
1
A
1
C
33
DD
To Next Page
Loading...
