19
FX3U Series Programmable Controllers
User's Manual - Hardware Edition
Standards
Requirement for Compliance with LVD directive
The following products have shown compliance through direct testing (of the identified standards below) and
design analysis (through the creation of a technical construction file) to the European Directive for Low
Voltage (2006/95/EC) when used as directed by the appropriate documentation.
Type : Programmable Controller (Open Type Equipment)
Models : MELSEC FX
3U series manufactured
Models : MELSEC FX2N series manufactured
For the products above, PLCs manufactured
before March 31st, 2002 are compliant with IEC1010-1
from April 1st, 2002 to April 30th, 2006 are compliant with EN61131-2:1994+A11:1996+A12:2000
after May 1st, 2006 are compliant with EN61131-2:2007
from May 1st, 2005 FX3U-MR/ES
Where indicates:16,32,48,64,80
from November 1st, 2005 FX3U-MT/ES FX3U-MT/ESS
Where indicates:16,32,48,64,80
from February 1st, 2006 FX
3U-128MR/ES FX3U-128MT/ES FX3U-128MT/ESS
FX3U-MR/DS
Where indicates:16,32,48,64,80
from September 1st, 2010 FX3U-MS/ES FX3U-MR/UA1
Where indicates:32,64
Standard Remark
EN61131-2:2007 Programmable controllers
- Equipment requirements and tests
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of EN61131-2:2007
from July 1st, 1997 FX2N-ER-ES/UL FX2N-ET-ESS/UL
Where indicates:32,48
FX
2N-16EYR-ES/UL
from April 1st, 1998 FX2N-48ER-DS
from August 1st, 1998 FX2N-48ER-UA1/UL
from August 1st, 2005 FX2N-8ER-ES/UL FX2N-8EYR-ES/UL
from September 1st, 2010 FX2N-8EYR-S-ES/UL
Standard Remark
IEC1010-1:1990 Safety requirements for electrical
/A1:1992 equipment for measurement, control,
and laboratory use
- General requirements
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of IEC 1010-1:1990+A1:1992
EN61131-2:1994 Programmable controllers
/A11:1996 - Equipment requirements and tests
/A12:2000
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of EN61131-2:1994+A11:1996+A12:2000
EN61131-2:2007 Programmable controllers
- Equipment requirements and tests
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of EN61131-2:2007
To Next Page
Loading...
