FX3U Series Programmable Controllers
User's Manual - Hardware Edition
86
5 Version Information and Peripheral Equipment Connectability
5.5 Other Peripheral Equipment Applicability
5.5 Other Peripheral Equipment Applicability
5.5.1 Other Peripheral Equipment Applicability
*1. The F940GOT and ET-940 whose version is former than Ver. 1.10 do not support the transparent (2-
port) function of the GX Developer.
Model name Applicability Remarks
GOT1000 Series
Applicable
(From first
product)
The GOT1000 Series is applicable to the device ranges in the
FX3U PLCs.
Check the applicability of other items in the GOT manual.
F940WGOT Applicable
For connection using the 2-port interface function
*1
, refer to
Section 5.4.
The following restriction applies when connected.
Contents of restrictions
Programming is enabled only in the function ranges such as
instructions, device ranges and program sizes available in the
FX
2N and FX2NC PLCs.
→ For applicable models, refer to the GOT manual.
F940GOT F940 Handy GOT Applicable
F930GOT(-K) Applicable
F920GOT(-K) Applicable
ET-940 Applicable
FX-10DM (-SET0) Applicable
The following restriction applies when connected.
Contents of restrictions
Programming is enabled only in the function ranges such as
instructions, device ranges and program sizes available in the
FX2N and FX2NC PLCs.
→ For supported models and device ranges,
refer to the FX-10DM USER'S MANUAL
(Manual No. JY992D86401).
FX-10DU(-E) Applicable
The following restriction applies when connected.
Contents of restrictions
It is limited to the device range and function range supported by
the highest class model (FX2N or FX2) applicable in the product
version.
→ For supported models and device ranges,
refer to the FX-10DU-E/FX-20DU-E User’s Manual
(Manual No. JY992D54801).
To Next Page
Loading...
Need help?
General
