EasyManuals Logo

Muratec MFX-3530 User Manual

Muratec MFX-3530
204 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #196 background imageLoading...
Page #196 background image
1
2
3
4
5
6
7
8
Error messages 8-3
Troubleshooting
Error code Error message Countermeasure
T.2.2 Confirm the remote fax. Transmit the document again. If this error
continues to occur, contact your local technical
representative.
ID check Tx error. ID does not
matched.
Check the settings on the other party’s machine.
ID check Tx error. No fax number
stored on remote fax.
Transmission error. Remote fax is
not compatible.
Transmission error. No passcode
stored in remote fax.
Transmission error. Passcode does
not matched.
Confirm the remote fax. Transmit the document again. If this error
continues to occur, contact your local technical
representative.
T.2.3 Cannot send with minimum speed. Transmit the document again. If this error
continues to occur, contact your local technical
representative.
T.3.1 Scanning error. Transmit the document again.
If you transmitted a document longer than 35.4"
(900 mm), cut the document so that it is within
35.4" (900 mm) and transmit it again.
If the screen “Lamp error. Checkout error” is
displayed after the error occurs, turn the power
of the machine OFF and then ON again, and
try making a copy. If the screen disappears,
transmit the document again. If the screen
does not disappear, contact your local technical
representative.
T.4.1 Confirm the remote fax. Transmit the document again. If this error
continues to occur, contact your local technical
representative.
T.4.2 The remote machine could not
receive document.
The transmitted pages were received but some of
them might have had poor image quality. Check
the image quality of the document received on
the other party’s machine.
T.5.1 Confirm the remote fax. Transmit the document again. If this error
continues to occur, contact your local technical
representative.
T.5.2 Confirm the remote fax.
T.5.3 Cannot send at minimum speed.
T.8.1 Cannot send a fax in Super G3
mode.
T.8.10
T.8.11
R.1.1 Confirm the remote fax. The sending party may have made an operational
mistake. If you know who the sending party is,
ask them to transmit the document again.

Table of Contents

Other manuals for Muratec MFX-3530

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Muratec MFX-3530 and is the answer not in the manual?

Muratec MFX-3530 Specifications

General IconGeneral
BrandMuratec
ModelMFX-3530
CategoryCopier
LanguageEnglish

Related product manuals