Installing the Operating System with Express Setup 5-9
Installing Windows Server 2003
Express Setup proceeds with the setup by specifying the necessary information on the wizard. You can also save the
setup information created on the wizard in a floppy disk to be used as a setup file.
NOTE: One floppy disk formatted by MS-DOS 1.44MB is necessary to save the setup
information. Please prepare a floppy disk before the installation.
Using the same setup file you saved and used before allows you to omit specifying the
setup information on the wizard.
And if you use a floppy disk which is attached to the optional device such as disk array
controller and contains device driver to install optional mass storage driver while
processing the Express Setup, you have to save the setup information in the setup file. In
this case prepare another empty floppy disk for the setup file.
1. Turn the power of the peripheral devices on, and then turn on the server.
NOTES:
îš„ If you install Windows Server 2003 with a MO device connected, the installation may
not complete normally. In such a case, detach the MO device and then re-install the
system from the beginning.
îš„ Connect data hard disk drives only after installing the OS.
îš„ If you create multiple logical drives in your system, refer to "Reinstalling the operation
system when multiple logical drives exist" (Appendix D).
2.
Insert the EXPRESSBUILDER CD-ROM into the CD-ROM drive of the server.
3. Press the RESET switch or press Ctrl, Alt, and Delete to reboot from the EXPRESSBUILDER. (You may
also turn off and then on again to reboot the server.)
The system will boot from the CD-ROM and EXPRESSBUILDER starts.
4. Click [Express Setup].
5. The message, "Do you want to use the parameter file in order to set up the Server or Workstation?", will be
displayed.
If you want to use a setup parameter file, click [Yes]. Click [No] if you don’t.
6. "Note" will be displayed. Read the instruction carefully and click [Confirm].
To Next Page
Loading...
Need help?
General
