5-10 Installing the Operating System with Express Setup
7. Notes and restrictions are displayed.
Read the messages carefully and click [Confirm].
NOTE: If an operating system has already been installed on the hard disk drive, a
message will ask whether you want to continue the setup.
If you wish to continue the installation, click [Continue].
8. If you selected "Yes" at step 5, place a floppy disk into the floppy disk drive mounted on the server.
NOTE: Do not remove the floppy disk from the server until prompted to do so.
If not, go on the next step.
[Using the existing Configuration Disk]
The parameters files in the floppy disk is listed in a dialogue-box.
1) Select a parameters file to use in the Express Setup.
After the parameters file is specified, the message "Do you want to review or modify the Setup File
parameters?" appears.
2) If you want to modify or confirm the parameters file, click [Review]. If not, click [Skip].
Click [Review] → Go on the next step.
Click [Skip] → Go on the step 10.
[Using a blank disk]
1) Click the box under [Setup File Name: (A)] or press
A.
The dialog box appears.
2) Input the file name and click [Use].
9. Confirm or modify the parameters of disk array configuration.
[Configure RAID] screen appears. Confirm the specification, modify if necessary, and then click [OK].
NOTE: Choose RAID0 when you install it in one hard disk drive.
When the dialogue-box is closed, the Express setup automatically performs the RAID configuration, creating
Maintenance partition and installing several utilities.
10. Select the Operating system to install.
Select "Windows" from the menu.
To Next Page
Loading...
Need help?
General
