Installing the Operating System with Express Setup 5-11
11. Select the Windows family.
Select "Microsoft Windows Server 2003 Standard Edition Microsoft Windows Server 2003 Enterprise
edition" category.
NOTE: If you select "Skip" at step 8, this menu does not appear.
Go on the step 13.
12. Next, [Basic Information] wizard appears. Confirm the parameters, modify if necessary, and then click [Next].
After that, click [Next], [Back], or [Help] on the screen to continue. Modify the parameters each time if
necessary.
IMPORTANT:
îš„ Reserve more than the minimum size for the partition on which the OS will be installed.
îš„ If you select "Use Existing Array" at "New/Existing RAID Configuration", the information
included in the first partition (excluding maintenance partition) will all be formatted and deleted. The
information included in the other partition will be retained. The figure below describes the partitions
for which information will be deleted when a maintenance partition exists.
First Partition
<Maintenance Partition>
Retained
Second
Partition
Deleted
Third
Partition
Retained
Fourth
Partition
Retained
îš„ You can not re-install the system in a partition of a hard disk drive upgraded to Dynamic Disk. Do
not select "Use Existing Array" at "New/Existing RAID Configuration".
îš„ You cannot re-install Windows Server 2003
îš„ If you specify other than 4095MB for the "Installing Partition", it is necessary to convert to NTFS.
îš„ If "Use Existing Array" at "New/Existing RAID Configuration" is selected but the partition other
than the one to install Windows Server 2003 does not exist (excluding maintenance partition),
Express Setup will reserve the maximum area of the hard disk drive to install Windows Server 2003.
îš„ You can not go to the next screen if the specification is incorrect.
îš„ On specification, an error may occur in relationship with the specified contents of the former screen
and require to go back to modify the specification.
îš„ During the setup, the screen to specify the partition that Windows Server 2003 is to be installed
appears. The first 55MB area displayed on the screen is a partition that is used to store the
configuration information or utilities unique of the server. We recommend you do not delete this area,
but if you do not want to reserve this 55MB area, perform the installation by manual setup. It is
impossible to delete this area using Express Setup.
NOTES:
îš„ If you click [Cancel] on the [Basic Information] screen, the screen will go back to select the OS.
[Cancel] exists only on the [Basic Information] screen.
îš„ If you click [OK] on the [Role of Computer] screen, the setup automatically selects default value
for the later specification to continue the installation.
13. Copy the modules for the optional mass storage driver.
If you want to install the optional mass storage driver, insert the floppy disk attached to mass storage driver
into the floppy disk drive and follow the message to operate the installation.
14. Remove the EXPRESSBUILDER CD-ROM from the CD-ROM drive according to the message.
If you proceed with the setup using setup parameter file, remove the floppy disk from the floppy disk drive.
Insert Windows Server 2003 CD-ROM into the CD-ROM drive.
[Agree Software License Agreement] screen appears.
To Next Page
Loading...
Need help?
General
