Configuring Your Server 4-7
CPU
To check the installed CPU status
Select [Main] - [Advanced Processor Options] – [Processor 1 CPUID] and check the status indications.
To clear the CPU error information
Select [Main] - [Advanced Processor Options] - [Processor Retest] – [Yes] and reboot.
Keyboard
To set Numlock
Select [Advanced] - [Numlock] – [On]/[Off].
Event Log
To clear event logs (when optional Remote Management Card is installed)
Select [Server] - [Event Log Configuration] - [Clear all Event Logs] and press
Enter.
Security
To set passwords on the BIOS
Select [Security] - [Set Supervisor Password] and enter a password.
Select [Security] - [Set User Password] and enter a password.
Set Supervisor password first, then User password.
External Devices
To set up external devices
Select [Advanced] - [I/O Device Configuration] and set up each device.
Internal Devices
To install the disk array controller board or SCSI controller board
Select [Advanced] - [PCI Configuration] - [PCI Slot n Option ROM] - [Enabled].
n: slot number
To clear the hardware configuration data (after installing/removing internal devices)
Select [Advanced] - [Reset Configuration Data] - [Yes].
To Next Page
Loading...
