Issue 4.1 UNIVERGE SV8100
3 - 36 Installing the SV8100 Chassis
11. Using the key-holes as a guide, slide the assembled unit over
the screws previously installed in the wall (refer to Figure 3-34
Install Screws (Option 2) on page 3-31).
12. Connect grounding wire to chassis. Refer to 2.8 Installing the
9.5” Chassis on page 3-54 for complete details on grounding
the system.
13. Refer to 2.8 Installing the 9.5” Chassis on page 3-54 to
continue installation of the chassis or, Chapter 6 paragraph 2.2
Installing an Extension or Trunk Blade on page 4-4 for
installation of blades.
2.6 Stand Mounting the 9.5” Chassis
The 9.5” chassis can be stand mounted using the brackets supplied. The
following section describes this procedure.
1. Lay the two bracket halves on a flat surface.
2. Using the slots on the sides of the 9.5” chassis as guides, insert the
stand mount brackets into the chassis (refer to Figure 3-41 Attach 9.5”
Stand Mount Bracket and Figure 3-42 Attach Remaining 9.5” Stand
Mount Bracket on page 3-37).
Figure 3-40 Position the 9.5” Stand Mount Brackets
To Next Page
Loading...
