NEC Univerge SV8100 - Connectors; LED Indications

Issue 4.1 UNIVERGE SV8100
4 - 96 Installing the SV8100 Blades
5.7.3 LED Indications
LED indications for the CD-4ODTB are listed in Table 4-52
CD-4ODTB LED Indications. Each LED is listed with its associated
function and LED and Operational status. Refer to Figure 4-32
CD-4ODTB Blade on page 4-94 for the location of the LEDs on the
blade.
5.7.4 Connectors
Table 4-53 CD-4ODTB RJ-61 Cable Connector Pin-Outs on page
4-97 shows the pin-outs for the RJ-61 connector. Refer to Figure
4-32 CD-4ODTB Blade on page 4-94 for an illustration showing the
location of the connectors on the ODT blade.
Table 4-52 CD-4ODTB LED Indications
LED Indication
Operation Status Remarks
Live LED
(Green)
Busy LED
(Red)
On On System Initializing –
Flash (1s) On The assignment of the unit is refused.
When you exceed the system
capacity.
When the main software
version is not matched.
Flash (1s) Trouble found during self-diagnostics. –
Flash
(100ms)
On
Normal
Operation
A Channel is busy (use
another from CH1 ~ CHx).
–
Off All channels are idle. –
Off
On
Unit Busy
A Channel is busy (use
another from CH1 ~ CHx).
–
Off All channels are idle. –
Flash (100ms
On/Off)
Downloading firmware. –