NEC Univerge SV8100 - Chapter 4 Installing the SV8100 Blades; Section 1 General Information; Slot Locations

System Hardware Manual 4 - 1
Chapter
4
Installing the SV8100 Blades
SECTION 1 GENERAL INFORMATION
This chapter contains information to help the technician install the blades
for the UNIVERGE SV8100 system. The technician should be familiar with
this section before installing any equipment.
1.1 Slot Locations
Each CHS2U has six slots. In the Controlling Chassis, the
CD-CP00 must be installed in the first slot (slot 1). In the CHS2U
GW, the CD-CP00 must be installed in the first slot (slot 1).
Slot Locations in the CHS2U (19” Controlling Chassis):
 Slot 1 – dedicated for the CPU
 Slots 2~6 – are universal
Slot Locating in the CHS2U (19” Expansion Chassis):
 Slots 1~6 are universal. (i.e., any type of blade can be installed
in these slots).
Slot Locations in the CHS2U GW (9.5” Controlling Chassis):
 Slot 1 – dedicated for the CPU
 Slots 2~3 – are universal