Issue 4.1 UNIVERGE SV8100
5 - 36 Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
4.7.1 Installing the Numbered Keypad on a Multiline Terminal
1. Remove the plastic panels. (Refer to paragraph Figure 5-33
Remove Plastic Panels.)
2. Pull down on the tab and lift the Numbered Keypad away from
the telephone to remove the existing button. See Figure 5-34
Removing Numbered Keypad from DT300/DT700 Series
Terminal.
Figure 5-33 Remove Plastic Panels
Figure 5-34 Removing Numbered Keypad from DT300/DT700
Series Terminal
To prevent possible damage to the Numbered
Keypad or the DTL/ITL multiline terminal during
installation or removal, disconnect the line cord/
LAN cable and the AC/DC adapter from the DTL/
ITL multiline terminal.
To Next Page
Loading...
