NEC Univerge SV8100 - LED Indications

UNIVERGE SV8100 Issue 4.1
System Hardware Manual 4 - 37
3.4.4 LED Indications
LED indications for the PZ-32IPLA, PZ-64IPLA and PZ-128IPLA
Daughter Boards are indicated in Table 4-17 IPLB Daughter Board
LED Indications. Each LED is listed with its associated function and
LED and Operational status. Refer to Figure 4-4 CD-CP00 Blade
with Daughter Boards Installed on page 4-17 for the location of the
LEDs on the blades.
The following table shows the LED indication when transmitting or
receiving data on CN1.
Table 4-15 IPLA Daughter Board LED Indications
LED Function LED Status Operation Status
Link 10/100
(LED 1)
10Base-T/100Base-TX link
speed indicator
On Red 100Base-TX link up
LINK 1000
(LED2)
1000Base-T link speed
indicator
On Red 1000Base-T link up
DUPLEX
(LED3)
Duplex Status On Yellow Full duplex operation
ACT
(LED4)
Link activity or data
transmission and reception
On Green Link up completed
Table 4-16 VOIPDB LED CN1 Transmit/Receive Data Indications
LED
Link Up
Auto Negotiation Mode Force Mode
1000
M bps
100Mbps 10Mbps
1000
M bps
100Mbps 10Mbps
Half Full Half Full Half Full Half Full
ACT (LED4) ON ON ON ON ON ON ON ON ON ON
DUPLEX (LED3) ON OFF ON OFF ON ON OFF ON OFF ON
LINK1000 (LED2) ON OFF OFF OFF OFF ON OFF OFF OFF OFF
LINK10_100
(LED1)
OFF ON ON OFF OFF OFF ON ON ON ON