Issue 4.1 UNIVERGE SV8100
4 - 36 Installing the SV8100 Blades
Table 4-14 IPLA Daughter Board Maximum Upgrade Capacities
provides the maximum capacities for the VOIPDB blades when they
are upgraded.
When installing a IPLA Daughter board, the system allocates the
maximum number of trunk ports for the blade being installed.
This daughter board is installed on either the CD-CP00.
3.4.2 Installation
To install a PZ-32IPLA/PZ-64IPLA/PZ-128IPLA on the CD-CP00 :
1. With the system power off, remove the CD-CP00.
2. Install the IPLA Daughter board onto the CD-CP00 blade.
3. Insert the CD-CP00 into slot 1 in the Controlling Chassis or.
. Refer to Figure 3-45 19” Controlling Chassis – Guides Slot 1 on page
3-41 for more details.
4. Connect the IPLA Daughter board to the CD-RTB or to an
external switching hub using an ethernet cable.
5. Refer to the Univerge SV8100 Programming Manual for
detailed programming instructions.
3.4.3 Switch Settings
These daughter boards do not have any switches that need to be set
and do not require any hardware setting.
Table 4-14 IPLA Daughter Board Maximum Upgrade Capacities
VOIPU
19”
Chassis
with CPU
19” Chassis
without CPU
19” Chassis
x4
Networked
Chassis
PZ-32IPLA 1 0 0 50
PZ-64IPLA 1 0 0 50
PZ-128IPLA 1 0 0 50
To Next Page
Loading...
