UNIVERGE SV8100 Issue 4.1
System Hardware Manual 4 - 31
3.3.2 Installation
To install a PZ-VM21 on the CD-CP00:
1. Included with the PZ-VM21 are four plastic spacers. Install the
plastic spacers onto the PZ-VM21. Make sure to attach the
spacers so that they extend out on the side of the daughter
board which has the CN1 connector. Refer to Figure 4-8
Installing the PZ-VM21 on page 4-32.
2. For installation on the CD-CP00 blade refer to Figure 4-4
CD-CP00 Blade with Daughter Boards Installed on page 4-17.
3. Position the PZ-VM21 CN1 connector over the CN4 connector
on the CD-CP00
blade. Press the boards together, ensuring
the plastic spacers lock in place.
4. Insert the CompactFlash card into the CN2 slot.
. The LED1 status lights steadily when a card is installed.
To Next Page
Loading...
