NEC Univerge SV8100 - Removing the Multiline Terminal from the Wall Mounted Plate

Issue 4.1 UNIVERGE SV8100
5 - 70 Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
6. Align the two holes on the back of the WM-L UNIT
with the two screws on the wall plate and slide
downward (refer to Figure 5-84 Mount Multiline
Terminal Wall on Wall Plate).
. Because of strength variation in switch boxes, this
method is not recommended.
7. Push excess line cord behind the Multiline Terminal.
5.2.10 Removing the Multiline Terminal from the Wall Mounted Plate.
To remove the Multiline Terminal, push up on the telephone until it
comes loose.
Figure 5-84 Mount Multiline Terminal Wall on Wall Plate
Figure 5-85 Removing the Multiline Terminal