Issue 4.1 UNIVERGE SV8100
4 - 24 Installing the SV8100 Blades
3.1.5 Connectors
Table 4-8 CD-CP00 Connections describes each connector on the
CD-CP00
, Table 4-9 CD-LTA RJ45 Cable Connector Pin-Outs
describes the pin-outs for connectors on the CCPU-A. Refer to
Figure 4-3 CD-CP00 Blade Layout on page 4-16 for the location of
the connections on the CD-CP00 blade.
Blinking Off On On On Steady When
USB Memory is
Installing
Flash memory booting error
Blinking On On On On Steady When
USB Memory is
Installing
Flash memory data error
Blinking Blinking Blinking Blinking On Steady When
USB Memory is
Installing
Reading error of system
program
On Off Off Off Off System starting up
Table 4-8 CD-CP00 Connections
Connector Connector Description
CN1 Backboard Connection
CN2 PZ-ME50 (Expanded Memory) Connection
CN3 PZ-32IPLA/PZ-64IPLA/PZ-128IPLA Blade Connection
CN4 PZ-VM21 Blade Connection
CN5 USB Memory Connection (used for upgrading software
or downloading system data)
CN6/SW2 Used for Debug Purposes
CN7 Ethernet Cable Connection (for PCPro or WebPro, CTI,
ACD MIS, IP Phone)
CN8/CN9 Pin Jack for External Source Connection (External
MOH, External Speaker, etc.)
CN10 External Source Control Connection
SW1 Load Switch
BAT Lithium Battery Socket (for backup of SRAM memory
data)
Table 4-7 CD-CP00 LED Indications (Continued)
LED Indication
Status
RUN (LED1) LED2 LED3 LED4 LED5
To Next Page
Loading...
