Issue 4.1 UNIVERGE SV8100
3 - 30 Installing the SV8100 Chassis
12. Refer to 2.8 Installing the 9.5” Chassis on page 3-54 to
continue installation of the chassis or 2.2 Installing an
Extension or Trunk Blade on page 4-4 for installation of blades.
2.5.2 Option 2
1. Use the template shown in Figure 3-28 Wall Mount Spacing
Guide (9.5” Chassis) on page 3-25 for required spacing before
drilling.
2. Mark and drill four holes.
3. Install four screws into the four drilled holes (refer to Figure
3-34 Install Screws (Option 2) on page 3-31).
Plywood should first be installed on the wall
where the chassis will be positioned. This
allows secure anchoring of the screws which
support the weight of the chassis.
To Next Page
Loading...
