NEC Univerge SV8100 - Wall Mounting the Bluetooth Cradle

Issue 4.1 UNIVERGE SV8100
5 - 84 Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
7.4.2 Wall Mounting the Bluetooth Cradle
Clearances required for installing the Bluetooth cradle are shown
below. Avoid mounting the cradle on a plaster-board wall, but before
mounting the cradle on a wall, check that the wall can withstand the
weight of the telephone and the load from pulling the telephone
during operation.
1. Attach two wood screws to the wall.
. Keep a clearance of about 0.08” (2mm) between each wood screw
and the wall (refer to Figure 5-104 Installing Wood Screws on page
5-85).
Figure 5-103 Wall Mount Spacing Guide BCH-L (BK) UNIT
To prevent possible damage to the BCH-L (BK)
UNIT due to falling, NEC recommends installing
the unit in a firm position so it will not fall due to its
own weight.