NEC Univerge SV8100 - Wall Mounting the Multiline Terminal

UNIVERGE SV8100 Issue 4.1
System Hardware Manual 5 - 45
4.10.1.2 Wall Mounting the Multiline Terminal
1. Plug line cord in the wall receptacle. Leave about
eight inches of cord and bundle the rest as shown in
Figure 5-45 Bundling the Line Cord.
2. Ensure the Tilt Legs are in the flat (unused position).
3. Plug the line cord into the Multiline Terminal as
illustrated in Figure 5-46 Plugging in Line Cord.
4. Align the two holes on the back of the multiline
terminal with the two screws on the wall plate and
slide downward (refer to Figure 5-47 Mount Multiline
Terminal Wall on Wall Plate on page 5-46).
Figure 5-45 Bundling the Line Cord
Figure 5-46 Plugging in Line Cord
Line In