Issue 4.1 UNIVERGE SV8100
4 - 78 Installing the SV8100 Blades
5.3.4 Connectors
Table 4-40 CD-2BRIA RJ-45 T-Bus Cable Connector Pin-Outs show
the pin-outs for the RJ-45 cable connector for S-Bus and T-Bus
connections. Refer to Figure 4-26 CD-2BRIA Blade on page 4-75 for
an illustration showing the location of the connectors on the
CD-2BRIA blade.
5.3.5 Termination Switch Settings
When the card is installed it may be necessary to change the
termination switch settings. These are found on the rear of the card,
each circuit has one 8-position DIP switch.
Table 4-40 CD-2BRIA RJ-45 T-Bus Cable Connector Pin-Outs
RJ-45 Cable Connector – CN2
S-Bus Connection
Pin No. Connection
1—
2—
3RA
4TA
5TB
6RB
7—
8—
RJ-45 Cable Connector – CN7, CN8
T-Bus Connection
Pin No. Connection
1
2TA
3RA
4RB
5TB
6TA
7
8
To Next Page
Loading...
