NEC Univerge SV8100 - Wall Mounting the Multiline Terminal; Adjusting the Hanger Hook; Wall Mounting a Multiline Terminal Using the Base Plate

Issue 4.1 UNIVERGE SV8100
5 - 44 Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
4.10 Wall Mounting the Multiline Terminal
You can wall mount a DT300/DT700 Series connection Multiline Terminal
using the base cover or an optional wall mount unit. A wall mount unit must be
used if adapters are installed on the Multiline Terminal.
4.10.1 Wall Mounting a Multiline Terminal using the Base Plate
4.10.1.1 Adjusting the Hanger Hook
1. Remove the hook from the unit.
2. Turn the hook with the tab toward the top.
3. Slide the hook until it glides into position forming the
hanger hook for the handset.
Figure 5-43 Removing the Hanger Hook on a
DT300/DT700 Series Terminal
Figure 5-44 Sliding the Hanger Hook into Position
Hanger Hook