NEC Univerge SV8100 - Installing the 19 Controlling Chassis

UNIVERGE SV8100 Issue 4.1
System Hardware Manual 3 - 41
2.7.3 Installing the 19” Controlling Chassis
1. Ensure the chassis is powered down.
2. Align the CD-CP00 blade with the Slot 1 guides of the
Controlling Chassis.
3. Slide the CD-CP00 blade into the chassis until resistance (back
plane) is felt.
Figure 3-45 19” Controlling Chassis – Guides Slot 1
Figure 3-46 Installing the CD-CP00
Blade
Do not remove or install this blade with the
power on.