UNIVERGE SV8100 Issue 4.1
System Hardware Manual 5 - 25
4.3 Connecting the IP Multiline Terminal to the Network and PC
These instructions for connecting an IP Multiline Terminal to the Network and
PC apply to DT700 Multiline Terminals. Refer to Figure 5-19 IP Terminal
Connector Locations.
1. Connect the LAN Network 10Base-T/100Base-TX cable to the LAN (=)
connector.
2. The IP terminal has a switching HUB to connect a PC to the LAN
Network. Connect the 10 Base-T/100 Base-TX straight cable used for
this connection to the PC(x) connector and to the PC.
Refer to Figure 5-20 Typical Network IP Connection on page 5-26.
Figure 5-19 IP Terminal Connector Locations
To Next Page
Loading...
