Issue 4.1 UNIVERGE SV8100
3 - 24 Installing the SV8100 Chassis
6. Connect the ground wire to all chassis. Refer to 2.7.5 Install 19” Chassis
Grounding on page 3-52 for complete details on grounding the system.
7. Refer to 2.7 Installing the 19” Chassis on page 3-39 to continue
installation of the chassis or, Chapter 5 paragraph 2.2 Installing an
Extension or Trunk Blade on page 4-4 for installation of blades.
2.5 Wall Mounting the 9.5” Chassis
When wall mounting the chassis, ensure the wall can support the weight of the
chassis and (25 lbs per system chassis ---- including blades, cords, power
supply, etc.). The chassis is secured to the wall with a wall mount bracket.
Optional wall mounting brackets exist for the 9.5” chassis (refer to Figure 3-27
Optional Wall Mounting Brackets for 9.5” Chassis). Option 1 attaches the
mounting bracket is secured to the wall and the chassis attached to the
bracket. Option 2 attaches the bracket to the 9.5” chassis and then, using the
key-holes as a guide, the assembled unit slides over screws secured to the
wall using the template shown in Figure 3-28 Wall Mount Spacing Guide (9.5”
Chassis) on page 3-25.
Figure 3-27 Optional Wall Mounting Brackets for 9.5” Chassis
To Next Page
Loading...
