UNIVERGE SV8100 Issue 4.1
System Hardware Manual 3 - 25
2.5.1 Option 1
1. Use the template shown in Figure 3-28 Wall Mount Spacing
Guide (9.5” Chassis) on page 3-25 for required spacing before
drilling.
2. Mark and drill four holes
3. Align the bracket halves with the precut holes in the metal
expansion fitting provided (refer to Figure 3-29 9.5” Mounting
Brackets and Metal Expansion Fitting on page 3-26).
Figure 3-28 Wall Mount Spacing Guide (9.5” Chassis)
Plywood should first be installed on the wall
where the chassis will be positioned. This
allows secure anchoring of the screws which
support the weight of the chassis.
To Next Page
Loading...
